Water Flow Sensor

₹ 400.00

In-Stock: 10

Category: Sensor Collections

Description:

 

  • Water flow sensor consists of a plastic valve body, a water rotor, and a hall-effect sensor. When water flows through the rotor, rotor rolls. Its speed changes with different rate of flow. The hall-effect sensor outputs the corresponding pulse Signal.

 

  • Hardware Installation You will need Seeeduino / Arduino ,Water Flow Sensor,10K resistor,a breadboard and some jumper wires. Wiring up the Water Flow Sensor is pretty simple. There are 3 wires: Black, Red, and Yellow. Black to the Seeeduino's ground pin Red to Seeeduino's 5v pin The yellow wire will need to be connected to a 10k pull up resistor.and then to pin 2 on the Seeeduino.

 

  Specifications :

 

Working voltage                 5V-24V
Power Source                 AC & DC
Weight                 43 g
Flow rate range                   1~30 L/min
Operating temperature                   0℃~80℃
Liquid temperature                   <120℃
Operating humidity                  35%~90%RH
Operating pressure                  under 1.2Mpa
Store temperature                  -25℃~+80℃